POWERNAIL 445FSW Use and Care Manual

Read this manual before you use this Stapler. Follow all safety warnings and instructions. Do not attempt any disassembly or repairs while the air li

10POWERSTAPLER MODEL 445FS

116TO CLEAR A NAIL JAM (continued):3. Separate the Foot and gate with a screw driver just enough to clear out the jammed nail.4. Put thread locking co

This chart will assist you in determining the proper length of PowerStaple® to use for various thicknesses of ooring. Approximate vertical penetratio

PROBLEM POSSIBLE CAUSE SOLUTION1Driving blade does not retract1. Zero of Low air pressure Check air supply for 70 psi minimum to 110 psi maximum2. Lac

2TO PREVENT ACCIDENTAL INJURIES:DESCRIPTIONThe PowerStapler® Model 445 FS Mallet Actuated Pneumatic Stapler is designed to bring Powernail quality to

WARNINGWhenever air is connected to the Stapler, keep body parts away from the staple discharge path. Disconnect the air line before making adjustmen

4PARTS & SERVICE: When ordering parts include the part number, part description, PowerStapler model and serial number. Be sure to state the quanti

hex with the 1-1/8” box wrench supplied.6. Push out the 1/4” diameter blade retaining Dowel Pin and remove the broken Driving Blade stub.7. Install a

reverse the direction of the chamfer when you replace the Rubber Seat.3. Replace the Rubber Seat, Support Ring and Cylinder Sleeve. Be sure to re inst

7For Step-by-Step Videos and Instructions, Visit our Web Site at www.Powernail.comWiper Seal. Saturate the new felt Wiper Seal with oil.Return Cylind

KEY: S=Sold Separately, A= Sold as part of assembly, K=Sold as part of a KitITEM #PART NO. DESCRIPTIONQTY. REQ’DKeyAssembly or Kit1 09-445-29320 BODY

KEY: S=Sold Separately, A= Sold as part of assembly, K=Sold as part of a KitAssemblies, Kits & AccessoriesMODELS 445FS PARTS LIST, CONTINUEDITEM #